Function
module | Operation | Keyboard and mouse can finish all operations |
|---|
X-ray tube
control | Using mouse to dlick the X button can turn on or off the X-ray.The
real-time tube voltage and current
value will display beside,users can click up and down button,ordrag
the slider,ortype to adjust. |
| Status bar | Indicates the interdock status,pre-heat status,and X-ray status by
flashing altemately red and green. |
Image effect
adjustment | The brightness,contrast and gain of the image can be adjusted
freely to achieve a satisfactory result. |
| Product list | Users can save the inspection parameters such as
Z-axis position,brightness,contrast and gain,and
can directly call the parameters when inspecting the
same product,to improwe the inspection efficiency. |
Navigation
window | After the camera takes a photo of the table,click anywhere in the
photo,the table will move to the
place you click and display on the screen. |
| Motion axis status | Display real-time coordinates. |
| Inspection result | The measurement results (voids rate,distance, area,etc.,set by
users)display in order. |
| Speed control | The mowement speed of each axis can be adjusted to slow,nomal and
fast. |
Voids rate
measurement | Automatic
calculation | Click on two points to determine a rectangle.The software
automatically finds and measures the
edge of the solder bal in the rectangle,the padand the intemal
voids,and can get the data of the voids
ratethe area of the solder ball,the circumference,the
biggestvoidsrate,the length and the width,and
indicates NG orOKby red and green. |
|---|
Parameters
adjustment | Users can adjust the grayscale threshold,pixel,contrast,size
filtering and other parameters to get accurate results of automatic calculation. |
Add voids
manually | Users can draw a polygon or a free figure and calculate it as a
void into the void rate. |
Save
parameters | Users can save parameters such as grayscale
threshold,pixcel,contrast,size filtening and otherparameters, and can directly call the parameterswhen detecting
the same product, to improve the detection efficiency. |
Other
measurement
function | Distance | Click the A and B points to set as the baseline, then click the C
point to measure the vertical distance
from the C point to the baseline |
|---|
| Distance rate | It is mostly used to measure the soldering rate of the
through-hole. Set one more point “D” than the
distance. Divide the vertical distance from the D point to baseline
by the vertical distance of the C
point, to obtain the percentage ratio of the vertical distance of D
to C. |
| Angle | Click the A and B points to set as the baseline, then click the C
point to measure the angle between the
BA and BC rays. |
| Radius | It is mostly used to measure round componentssuch as solder balls.
Click three points to determine
a circle and measure the circumference, area and radius. |
| Perimeter | It is mostly used to measure square components,click two points to
determine a square, measure the
length, width and area |
